Important Notice - Our operations are closed during Holi festival from 19th March to 22nd March 2019. All the order placed during this period will be dispatched on Monday, 25th March 2019. Orders placed on 18th March till midnight will be dispatched as usual without any delays.


 

ST-LINK/V2 (CN) - STM8 / STM32 Programmer & Debugger
Make: Made in China
SKU: R-1719
Availability: IN STOCK

₹​ 1,199.00
Qty:
 


Additional Info
  • Prices shown are exclusive of tax.
  • GST Invoice on all orders for Input Tax Credit.
  • Economy shipping at flat ₹49.
  • Free economy shipping on order amount > ₹1999.
  • Quick support through Whatsapp @+917231066325

  • ST-LINK/V2 (CN) - STM8 / STM32 Programmer & Debugger

    The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.

    • STM8 applications use the USB full speed interface to communicate with STMicroelectronic's ST Visual Develop (STVD) or ST Visual Program (STVP) software.
    • STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments.

    Features

    • 5 V power supplied by a USB connector
    • USB 2.0 full speed compatible interface
    • USB standard A to mini B cable
    • SWIM specific features
    • 1.65 V to 5.5 V application voltage supported on SWIM interface
    • SWIM low-speed and high-speed modes supported
    • SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
    • SWIM cable for connection to the application via an ERNI standard vertical (ref: 284697 or 214017) or horizontal (ref: 214012) connector
    • SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
    • JTAG specific features
      • 1.65 V to 3.6 V application voltage supported on the JTAG interface and 5 V tolerant inputs
      • JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector
    • Direct firmware update feature supported (DFU)
    • Status LED which blinks during communication with the PC
    • Operating temperature 0 to 50 °C

     


    Device Drivers

    While connecting the ST-LINK/V2 to the computer through USB interface, the USB driver is required and should be installed correctly first.

    Click on the link below to download:

    ST-LINK/V2 USB driver for Windows 7, Vista and XP


    ST Link LED status

    The LED labeled 'COM' on top of the ST-LINK/V2 shows the ST-LINK/V2 status (whatever the connection type). When the:

    • LED is blinking RED: the first USB enumeration with the PC is taking place. If it keeps blinking RED, maybe the USB driver is NOT found.
    • LED is RED: communication between ST-LINK/V2 and the PC is established (end of enumeration).
    • LED is blinking GREEN/RED: data are being exchanged between the target and the PC.
    • LED is GREEN: the last communication has been successful.
    • LED is ORANGE: ST-LINK/V2 communication with the target has failed.

     

    Write a review

    Your Name:


    Your Review: Note: HTML is not translated!

    Rating: Bad           Good

    Enter the code in the box below: