e-Paper IoT Driver HAT for Raspberry Pi, Supports NB-IoT/eMTC/GPRS - SIM7000E
Make: WaveShare Electronics Co.
SKU: 2206
Availability: Sold Out

₹3,053.84 inc. GST
Ex GST: ₹2,588.00
Qty:
 


Additional Info
  • Prices shown are Including GST.
  • B2B GST Credit Available.
  • Economy shipping at flat ₹49.
  • Free shipping on value > ₹2499.
  • Whatsapp Support @+917231066325

  • This is a Raspberry Pi IoT driver board for e-Paper raw panels. It allows getting text/image data from IoT clouds through NB-IoT/eMTC/EDGE/GPRS network connection, and then display them on the e-Paper. Applications includes any scenario where remote refresh of display is required such as shelf display etc.


    Package Includes

    • e-Paper NB-IoT/GPRS HAT x1
    • LTE full bands PCB antenna x1
    • e-Paper Adapter x1
    • 24PIN FFC x1
    • 2×20PIN female pinheader x1
    • RPi screws pack (2pcs) x1

    Development Resources

    Wiki Page  - http://www.waveshare.com/wiki/e-Paper_NB-IoT_GPRS_HAT


    • Onboard SIM7000E module, controlled via UART, supports NB-IoT/eMTC/EDGE/GPRS communication
    • e-Paper interface, controlled via SPI, compatible with various Waveshare SPI e-Paper raw panels
    • Standard Raspberry Pi 40PIN GPIO extension header, supports Raspberry Pi series boards
    • Breakout SIM7000E and e-Paper control pins, for connecting with host control boards like STM32
    • 3.7V lithium battery port and charging circuit, provides power to SIM7000E module or external 3.3V system (5V system like Raspberry Pi requires another power supply)
    • Onboard voltage translator, select 3.3V/5V operating voltage by switch
    • Provides Windows host code (based on Alibaba Cloud), make it easy to study/develop, or integrate it into IoT applications
    • Comes with development resources and manual (examples for Raspberry Pi/STM32)

    • Communication interface: UART + SPI (4-wire SPI by default, switch to 3-wire SPI by soldering)
    • Communication module: SIM7000E
    • Quad-Band LTE-FDD B3/B8/B20/B28
    • GPRS/EDGE 900/1800Mhz
    • GNSS (GPS, GLONASS, BeiDou, and Galileo, GNSS antenna is required and NOT included)
    • Support SIM card: NB-IoT specific card, or 1.8V/3V normal SIM card
    • Power supply voltage: 5V
    • Logic level: 5V / 3.3V
    • Applicable battery: 3.7V lithium battery via PH2.0 connector (NOT included)
    • Dimensions: 56.5mm x 65mm

     

    Write a review

    Your Name:


    Your Review: Note: HTML is not translated!

    Rating: Bad           Good

    Enter the code in the box below: