ST-LINK/V2 (CN) - STM8 / STM32 Programmer & Debugger
Make: Made in China
SKU: R-1719
Availability: Sold Out

₹1,414.82 inc. GST
Ex GST: ₹1,199.00
Qty:
 


Additional Info
  • Prices shown are Including GST.
  • B2B GST Credit Available.
  • Economy shipping at flat ₹59.
  • Free shipping on value > ₹2499.
  • Whatsapp Support @+917231066325
  • Estimated Delivery time?
  • Manufacturing Services

  • ST-LINK/V2 (CN) - STM8 / STM32 Programmer & Debugger

    The ST-LINK/V2 is an in-circuit debugger and programmer for the STM8 and STM32 microcontroller families. The single wire interface module (SWIM) and JTAG/serial wire debugging (SWD) interfaces are used to communicate with any STM8 or STM32 microcontroller located on an application board.

    • STM8 applications use the USB full speed interface to communicate with STMicroelectronic's ST Visual Develop (STVD) or ST Visual Program (STVP) software.
    • STM32 applications use the USB full speed interface to communicate with Atollic, IAR, Keil or TASKING integrated development environments.

    Features

    • 5 V power supplied by a USB connector
    • USB 2.0 full speed compatible interface
    • USB standard A to mini B cable
    • SWIM specific features
    • 1.65 V to 5.5 V application voltage supported on SWIM interface
    • SWIM low-speed and high-speed modes supported
    • SWIM programming speed rate: 9.7 Kbytes/s in low speed and 12.8 Kbytes/s in high speed
    • SWIM cable for connection to the application via an ERNI standard vertical (ref: 284697 or 214017) or horizontal (ref: 214012) connector
    • SWIM cable for connection to the application via a pin header or a 2.54 mm pitch connector
    • JTAG specific features
      • 1.65 V to 3.6 V application voltage supported on the JTAG interface and 5 V tolerant inputs
      • JTAG cable for connection to a standard JTAG 20-pin pitch 2.54 mm connector
    • Direct firmware update feature supported (DFU)
    • Status LED which blinks during communication with the PC
    • Operating temperature 0 to 50 °C

     


    Device Drivers

    While connecting the ST-LINK/V2 to the computer through USB interface, the USB driver is required and should be installed correctly first.

    Click on the link below to download:

    ST-LINK/V2 USB driver for Windows 7, Vista and XP


    ST Link LED status

    The LED labeled 'COM' on top of the ST-LINK/V2 shows the ST-LINK/V2 status (whatever the connection type). When the:

    • LED is blinking RED: the first USB enumeration with the PC is taking place. If it keeps blinking RED, maybe the USB driver is NOT found.
    • LED is RED: communication between ST-LINK/V2 and the PC is established (end of enumeration).
    • LED is blinking GREEN/RED: data are being exchanged between the target and the PC.
    • LED is GREEN: the last communication has been successful.
    • LED is ORANGE: ST-LINK/V2 communication with the target has failed.

     

    Write a review

    Your Name:


    Your Review: Note: HTML is not translated!

    Rating: Bad           Good

    Enter the code in the box below: